Black Oval Closet Rod End Brackets (Rear Pin – 5mm) | 15mm x 30mm | Desunia

Designed for a clean, built-in look—no screws required.
These rear pin brackets are designed specifically for oval closet rods and are made for use with closet systems that have pre-drilled 5mm holes. If your panels are already set up for pins, this is the simplest and cleanest way to install your rod.

No measuring, no drilling—just insert the pins and you’re ready to go.

A secure fit—with a few smart details built in.
These brackets are designed to work with standard 5mm hole patterns commonly found in closet organizers and wardrobe systems.

Each rear pin features four tapered ridges that create a slight “bite” as the bracket is pressed into place, helping it seat firmly for a snug, secure fit—even if the holes are slightly worn or oversized.

We also include a small screw that can be used if needed, to keep the bracket firmly seated against the panel.

Adjustable, without the damage.
Because the brackets install using pins instead of screws, they can be repositioned easily along the panel.

That means you can raise or lower your rod in seconds without drilling holes in your furniture—perfect for evolving storage needs.

Works with wood cleating, too.
While these are primarily designed for pre-drilled panels, they can also be installed into wood cleating.

Each pin has a small marking dimple that helps locate your holes—just press the bracket into place and it will leave a light impression in the wood so you know exactly where to drill.

• Drill the top hole first
• Insert the top pin slightly (about 1/16")
• Press to mark the bottom hole location
• Drill and install

One advantage of this method is a completely clean look—no visible screws once the rod is installed.

Solid cast construction—not stamped shortcuts.
These are made from cast zinc—not thin stamped metal that’s cranked out by the thousands.

Casting creates a denser, more substantial part with cleaner lines and smoother edges. Each bracket is embossed with our Desunia “D”, so you know you’re getting the real thing—not a generic lookalike.

A smoother finish starts before the finish.
A great black finish starts with a properly prepared surface.

Before coating, each bracket is smoothed and refined to create a clean, consistent base. Then a durable powder coat is applied and cured—creating a tougher, more uniform finish than typical painted or enamel coatings.

The result is a deep, consistent black that resists chipping, scratching, and everyday wear, even with constant hanger movement—and matches seamlessly with our rods and other components for a cohesive look throughout your space.

Simple install—if your panels are ready.

• Insert the rear pins into pre-drilled 5mm holes
• Press firmly until fully seated
• Set your rod in place

That’s it—no tools required. These are not designed for drywall installations.

Here’s what you get…

• 1 pair of black oval closet rod rear pin brackets
• Optional retaining screws